SATO S84NX - Page 184

[Network]
184
• Some symbols cannot be used. If you enter a symbol that cannot be used, [Invalid
value] appears on the screen.
• Periods can be input only as delimiter text.
• If left blank, the setting is disabled.
[Wi-Fi]
Set the wireless LAN.
Appears only if you have installed the optional wireless LAN.
•
After doing the settings, press the button to enable the new settings. Press
the button to cancel the new settings and return to the previous settings.
• When [Wi-Fi Direct] is active, [IPv6] and [Wi-Fi Protected Setup] do not appear on the
screen.
The setting items are as follows:
[IPv4]
Configure IPv4 for Wi-Fi.
•
After doing the settings, return to the [Wi-Fi] screen by pressing the button, and
then press the button to enable the new settings. Press the button
to cancel the new settings and return to the previous settings.
• When [Wi-Fi Direct] is active, [Mode], [DHCP] and [DNS] do not appear. In addition,
you cannot change [IP Address], [Netmask], or [Gateway] if [DHCP] or [Wi-Fi Direct] is
active. [DNS] cannot be changed if [Mode] is [DHCP].
The setting items are as follows:
[Mode]
Select the IP address assignment method.
The options are as follows:
DHCP
Automatically retrieve the IP address, gateway and subnet mask from the DHCP server.
Static
Manually set the IP address, gateway and subnet mask.
[DHCP]
Update the lease time and get the IP address from the DHCP server again.
Appears only if you have selected [DHCP] in the [Mode] menu.