185
Does not appear if LAN is the active interface.
[IP Address]
If you have selected [Static] in the [Mode] menu, set the IP address.
The setting range is as follows:
000.000.000.000 to 255.255.255.255
[Netmask]
If you have selected [Static] in the [Mode] menu, set the subnet mask address.
Each group of the address can be set cyclically among 0, 128, 192, 224, 240, 248, 252, 254 and 255.
The setting range is as follows:
128.000.000.000 to 255.255.255.254
[Gateway]
If you have selected [Static] in the [Mode] menu, set the default gateway address.
The setting range is as follows:
000.000.000.000 to 255.255.255.255
[DNS]
If you have selected [Static] in the [Mode] menu, set and check DNS server addresses.
The setting range is as follows:
000.000.000.000 to 255.255.255.255
• You can register up to three IP addresses for the DNS server. Use a comma to delimit
different IP addresses.
[IPv6]
Configure IPv6 for Wi-Fi.
•
After doing the settings, return to the [Wi-Fi] screen by pressing the button, and
then press the button to enable the new settings. Press the button
to cancel the new settings and return to the previous settings.
• When [Wi-Fi Direct] is active, this [IPv6] screen does not appear. In addition, you
cannot change [IP Address], [Prefix Length], [Gateway], or [DNS] if [Mode] is anything
other than [Static].
The setting items are as follows:
[Mode]
Select the IP address assignment method or disable IPv6.
The options are as follows:
Disable
Disable IPv6.
To Next Page
Loading...