187
Enabled
Enable proxy server usage.
Disabled
Disable proxy server usage.
• To enable the proxy, [Server] should be set and [Exclude] must contain at least
127.0.0.1 and localhost.
[Server]
Set the name or IP address of the proxy server.
Example of input) http://172.128.1.100
• Be sure to specify a format for the IP address that starts with http. If you specify an
address that starts with https, then the certification check is not done and connection to
a legitimate SOS server may be impossible.
• Server should be set with a valid name or IP address.
[Port No.]
Set the port number that allows communication with the proxy server.
The setting range is from 1 to 65535.
• Set a port number not used by other services. If port numbers that overlap with those
used by other services are used, communication cannot be performed properly.
• To set the port number, [Server] should be set.
[Username]
Set the username if you need a username to connect to the proxy server.
You can enter 1 to 8 characters. Alphabets (capital and small letters) and numbers can be used.
• To set the username, [Server] should be set.
[Password]
Set the password if you need a password to connect to the proxy server.
You can enter 1 to 16 characters. Alphabets (capital and small letters), numbers and symbols can be
used.
• Some symbols cannot be used. If you enter a symbol that cannot be used, [Invalid
value] appears on the screen.
To Next Page
Loading...