[RFID] (S84NX Only)
232
Pressing the button (ABORT) deletes the one current item, and then starts printing the
next.
Example:
◦ If one copy each of 10 items are being printed, the current item is deleted, and the remaining
items are printed.
◦ If 10 copies of one item are being printed, the current item is deleted, and then printing stops.
• To cancel an entire print job, open and close the top cover to switch the product to
Offline mode, and then press the button (CANCEL).
[Retries]
Set the number of times the retry/release operations as set in [Retry Mode] are repeated before
printing stops and the RFID error screen opens, when an RFID error occurs.
The setting range is from 0 to 9.
If you set to 0, the RFID error screen appears and printing continues.
[Mark bad tags]
Set the error print for the RFID tag error.
Enabled
Enable the RFID error print function.
Disabled
Disable the RFID error print function.
[RFID Undetected Warning]
To prevent wasting RFID tags, set whether to stop printing and display an RFID undetected warning
error if there is no RFID command in the print job.
The RFID commands that are detected by this function are EPC code write <IP0> and UID/EPC/IDm
print <TU> commands.
The options are as follows:
Disable
The RFID undetected warning error is not displayed. Printing continues.
RFID Tag
Printing stops and an RFID undetected warning error is displayed if there is no RFID command in
the print job when an RFID tag is loaded.
The error is no longer displayed if the media is replaced with normal labels.
RFID Command
Printing stops and an RFID undetected warning error is displayed if there is no RFID command in
the print job.
To Next Page
Loading...