233
• An RFID undetected warning is displayed even when using an RFID command that
is intended to be detected in the print job, if it is written in the data that caused the
command error.
[Log RFID Data]
Set the log function to record the encoded tag information.
The log data can record up to 100 inlays of information. When the log file reaches its maximum size,
the new log data overwrites the older log data.
All the log data will be lost if the product is powered off.
The options are as follows:
Enabled
Enable the log function to record the RFID data.
Disabled
Disable the log function to record the RFID data.
[Data To Record]
Set the data to record the log when [Log RFID Data] is enabled.
The options are as follows:
EPC and TID
Store the EPC and TID data.
EPC
Store the EPC data.
TID
Store the TID data.
[Output Error Mode]
Set the signal type for RFID errors.
The options are as follows:
Pulse
Outputs a pulse as the output signal when an RFID error occurs.
Level
Outputs a level as the output signal when an RFID error occurs.
[Pulse Length]
Set the length of an RFID error pulse.
Appears only if you have selected [Pulse] in the [Output Error Mode] menu.
The options are as follows:
To Next Page
Loading...