Segway VILLIAN SSV Series - Camshaft Cover; Camshaft; Install the Tensioner; Remove the Tensioner

CYLINDER HEAD, CYLINDER, PISTON
CYLINDER HEAD, CYLINDER, PISTON
3-5-15
Camshaft cover / camshaft
Remove the tensioner
!
CAUTION
CAUTION
This is a non-return type timing chain tensioner.
Once the push rod of the tensioner extends out of the
tensioning chain, it cannot return to the initial position.
Observe all the following rules:
When removing the tensioner, do not unscrew only
part of the mounting bolts. Retightening the mounting
bolts from this position may damage the tensioner and
timing chain. After the bolts are loosened, the tensioner
must be removed according to the instructions in
"Timing Chain Tensioner Installation" and returned to its
position.
After the tensioner is removed, do not turn the
crankshaft. This may change the timing position and
damage the valve
A
A
D
D
B
B
C
C
E
E
F
F
G
G
H
H
Install the tensioner
◆
Remove the tensioner adjusting hole bolt
【
D
】
,
remove the O-ring
【
E
】
and the tension rod spring
【
F
】
.
◆
Toggle the locking block
【
G
】
, and press the
adjusting rod
【
H
】
into the tensioner.
◆
Replace with a new tensioner gasket
【
C
】
.
◆
Align the tensioner with the installation hole and
install it, and screw in the tensioner bolt
【
A
】
.
◆
Put
【
E
】
on the bolt
【
D
】
, and install the spring
【
F
】
and bolt
【
D
】
in sequence.
◆
Tightening torque
Chain tensioner mounting bolt
9.8 N
•
m (1.0 kgf
•
m, 87 in
•
lb)
Tensioner adjusting hole bolt
12 N
•
m(1.2 kgf
•
m,8.8 ft
•
lb)
◆
Disassembly:
【
A
】
Bolt M6×25
【
B
】
Tensioner combination
【
C
】
Tensioner gasket