14 - 93
ELECTRICAL SYSTEM
A
B
C
D
Install winch motor
◆ The order of assembly and disassembly is reverse,
install the winch motor and connect the cables;
◆ Then connect the battery.
◆
!
winch work shall not exceed 1min each time, and shall
work after 30S interval
◆ Rated working voltage DC12V
◆ The maximum working tension is 3500LB,
◆ The maximum working current ≤ 1 8 5 A, the
maximum working current lasts for 1 min, and works
after an interval of 30 seconds, and continues to
work in this way
◆ The diameter of the wire rope is 4.8, and the length
of the wire rope is 14.5 meters
The color of the insulation pad of the winch motor
terminal and the heat shrinkable tube of the cable is one-
to-one correspondence
【A】YELLOW
【B】BLUE
【C】NUT
Torque of nut【C】
4 N·m（0.4 kgf·m，2.9ft·lbs）
The winch motor is a component that cannot be
repaired. If the winch motor is faulty, the component
must be replaced in time.
The color of the winch relay terminal corresponds to the
color of the heat shrinkable tube of the cable one-to-one
【C】YELLOW
【D】BLACK
【E】RED
【F】BLUE
The winch relay is a component that cannot be repaired.
If the winch relay is faulty, the component must be
replaced in time.
B
A
C
C
To Next Page
Loading...
