8 - 10
DRIVE SYSTEM
DRIVE SHAFT REMOVAL
D
B
A
C
E
◆ The removal method of the front and back constant
speed drive shaft is the same;
【A】 cotter
【B】 nut
【C】 gasket
【D】 bolt
【E】 Hub mounting seat
◆ Park the vehicle in the horizontal position, with a
jack or support frame to raise the vehicle, so that the
wheels do not touch the ground, and then remove
the front tire;
◆ Remove the split pin 【A】 and nut 【B】, remove
the washer 【C】;
Bolt [B] Torque
300 N·m（30.6 kgf·m，220ft·lbs）
◆ Remove the brake caliper mounting bolt 【D】,
remove the brake caliper;
Bolt [B] Torque
70 N·m（7.1 kgf·m，52ft·lbs）
◆ Take out the rim mounting seat along the arrow
direction 【E】;
To Next Page
Loading...
