2 - 32
MAINTENANCE
The front and rear brakes are hydraulic disc type brakes
activated by the brake pedal.
!
Brake fl uid levels must be checked periodically:
overfi lling of the brake cylinder may cause brake
resistance or brake locking, which may result in serious
injury or death. Keep brake fl uid at the recommended
level and do not overfi ll. Must check brake disc brake
disc wear condition regularly: if brake disc wear, should
be replaced.
The following inspection is recommended to keep the
braking system in good working condition. If the brake is
in heavy use during normal operation, check it frequently.
◆ Always keep the brake fl uid at an appropriate level.
Please refer to master cylinder/brake fluid section
for details.
◆ Check the braking system for liquid leakage.
◆ Check whether the brake travels too long or feels
soft.
◆ Check whether the friction gasket is worn, damaged
or loose. When replacing the brake gasket, the
brake pad must be replaced when the remaining
limit thickness of the brake pad is not less than
1mm.
◆
Check the safety and surface condition of the disc.
Use the recommended brake cleaner or liqueur to
clean any grease. Do not use spray lubricants or
other petroleum-based products. If any damage
(crack, excessive corrosion, warping) is found,
please check the dealer's service before operation.
BRAKE SYSTEM
前左
制动
后左
制动
制动
液杯
制动
踏板
前右
制动
后右
制动
To Next Page
Loading...
