Segway VILLIAN SSV Series - Install the Gear Assembly; Install the Main Shaft Assembly; Install the Right Box Body Combination

4 - 25
FRONT AXLE AND REAR GEARBOX
FRONT AXLE AND REAR GEARBOX
A
A
B
B
A
A
B
B
Install the main shaft assembly
【
A
】
Bushing
【
B
】
Main shaft
◆
Tools: copper hammer.
◆
Press
【
A
】
into
【
B
】
according to the icon.
Install the gear assembly
【
A
】
Reverse gear idler shaft assembly
【
B
】
Main shaft assembly
【
C
】
Rear axle output gear assembly
◆
First put
【
A
】
into the left box body according to
the fi gure, then put
【
B
】
into the left box body, and
fi nally put
【
C
】
into the left box body.
!
!
CAUTION
When installing the
【
C
】
rear axle output gear, pay attention
to the gap between the gear and the box body to prevent
fi ngers from being pinched.
Install the right box body combination
【
A
】
Right gearbox
【
B
】
Bolt M8×40
【
C
】
Bolt M8×60
◆
Tool: 10mm sleeve.
◆
Apply sealant according to the gluing track as shown
in the fi gure. The glue application should be uniform
and continuous, and the glue line width should be
about 1.5-2mm.
◆
Align with the positioning pin hole of the left
box body, install
【
A
】
, and tighten the bolts in
sequence.
Bolt M8×40
12N·m
(1.22kgf·m,8.86ft·lb)
(1.22kgf·m,8.86ft·lb)
Bolt M8×60
12N·m
(1.22kgf·m,8.86ft·lb)
(1.22kgf·m,8.86ft·lb)
A
A
B
B
C
C
胶线轨迹
A
A
B
B
C
C