Segway VILLIAN SSV Series - Disassemble; Inspection of Parts Wear; Install

4 - 8
FRONT AXLE AND REAR GEARBOX
FRONT AXLE AND REAR GEARBOX
!
!
WARNING
WARNING
If it is not replaced in time, it will cause abnormal wear
of other parts, and the overall temperature of the
gearbox will increase, which will shorten its service life.
【
A
】
Hexagon fl ange bolt m8×25
【
B
】
Front axle end cover
【
C
】
Limiting liner
【
D
】
Rectangular gasket
【
E
】
Front axle end cover assembly
A
A
B
B
DISASSEMBLE
◆
Tool: 10mm t-sleeve (air trigger gun)
◆
Rotate c (7 pcs) counterclockwise to unscrew, pry b
(three points) to take out e
◆
Take out c and measure the thickness. If the
thickness is less than 6.85Mm, a new limit gasket a
needs to be replaced.
Install
◆
Tool: 10mm T-sleeve (air trigger gun)
◆
Install C in B, pay attention that the boss of C
corresponds to the groove of B
◆
Check D, there must be no distortion or damage, if
any, please replace it in time
◆
Then assemble E as a whole back to the front axle
housing, and tighten bolt A diagonally.
!
!
WARNING
WARNING
If the oil leaks during the replacement, please make
up the oil and check whether the oil seal and sealing
ring on B are damaged. If there is any damage, please
replace it in time.
C
C
D
D
Inspection of parts wear
A
A
E
E