10 - 7
WHEELS AND TIRES
Front bundle adjustment
[A] lock nut
[B] lock nut
◆ 【C】 Pull rod
◆ Loosen the lock nut [A] [B] and adjust the pull rod [C]
the same number of turns on both sides to reach the
specifi ed front bundle.
◆ Lock nut [A] on tie rod is left screw thread. Loosen
the lock nut by turning it clockwise.
◆ If the front bundle reaches the specifi ed value, the
length of each tie rod
（1）SGW1000F-S1/SGW1000F-S3/SGW1000F-S5：
（512～542）mm (20～21inch)
（2）SGW1000F-S2/SGW1000F-S4/SGW1000F-S6：
（593～623）mm (23～24.5inch)
!
Adjust the length of the tie rod so that the visible thread
length at both ends of the tie rod 【E】 is even,Uneven
thread length can cause damage to the end of the tie
rod.
◆ Check the front bundle.
◆ Tighten：
The tie rod adjusts the torque of the locking nut
50 ～ 60 N.m
◆ Test drive vehicle.
A
C B
To Next Page
Loading...
