Segway VILLIAN SSV Series - Battery; Battery Installation; Remove the Battery

14 - 10
ELECTRICAL SYSTEM
A
B
C
Remove the battery
【A】Positive pole
【B】Negative pole
◆ Turn off the ignition switch.
◆ Remove seat (see the Frame Section)
◆ Loosen the bolt of the battery seat.
◆ Remove battery fi xing tape.
◆ Disconnect the battery negative (-) cable first, and
then disconnect the positive (+) cable.
◆ Take out the battery.
Battery installation
◆ Turn off the ignition switch.
◆ Put the battery with the battery box and fixer in
place.
◆ Connect the positive cable first, and then connect
the negative cable.
◆
Apply a thin layer of grease to the terminal to
prevent corrosion.
◆ Tighten battery seat bolts.
Match the model type of the battery. The name should be
the same.
Battery type Name：GHD32HL-BS
!
This battery is a colloidal battery and does not need to
add electrolyte.
BATTERY