Segway VILLIAN SSV Series - Check Left Crankcase Cover; Crankcase\Crankshaft\Balance Shaft; Install Left Crankcase Cover

CRANKCASE\CRANKSHAFT\BALANCE SHAFT
3-4-13
check left crankcase cover
◆
◆
Check the state of bearing
Check the state of bearing
【
【
A
A
】
】
, wire harness
, wire harness
【
【
B
B
】
】
, stator coil
, stator coil
【
【
C
C
】
】
.
.
◆
◆
If you need to replace the bearing, can be heated by
If you need to replace the bearing, can be heated by
the left crankcase cover bearing hole or use special
the left crankcase cover bearing hole or use special
bearing disassembly tools to remove the bearing.
bearing disassembly tools to remove the bearing.
install left crankcase cover
◆
Align the left crankcase cover assembly
【
B
】
and
the new gasket
【
A
】
with the positioning pins on
the crankcase and load into the left crankcase cover.
!
CAUTION
CAUTION
The magneto rotor is magnetic, so be careful when
installing and removing the left crankcase cover. Do not
place your fi nger between the left crankcase cover and
the crankcase to avoid injury.
◆
Tighten the bolts in sequence
Bolt
9.8 N·m (1 kgf·m, 87 in•lb)
A
A
A
A
B
B
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
B
B
C
C