Segway VILLIAN SSV Series - Bearing Replacement

8- 7
DRIVE SYSTEM
A
B
D
D
C
BEARING REPLACEMENT
【A】Retaining ring for hole
【B】Spline fork
【C】Bearing
【D】Welding fork
◆ Retaining ring for disassembly hole【A】
◆ Fix the welding fork【D】on the clamp, hit the spline
fork【B】, and take out the roller needle bearing
group to separate the spline fork from the ten-byte
bearing;
◆ Fix the ten-byte bearing on the clamp, hit the
welding fork【D】, and take out the roller needle
bearing set to separate the welding fork from the
ten-byte bearing
◆ Replace the cross shaft bearing and assemble it
in reverse according to the disassembly procedure
above.