Segway VILLIAN SSV Series - Install the Intake Pipe Assembly; Install Thermostat and Water Temperature Sensor; Remove the Intake Pipe Assembly

CYLINDER HEAD, CYLINDER, PISTON
CYLINDER HEAD, CYLINDER, PISTON
3-5-26
Remove the intake pipe assembly
◆
Disassembly:
【
A
】
Bolt M6×25
【
B
】
Intake pipe assembly
Install the intake pipe assembly
◆
Install the intake pipe assembly
【
B
】
, and tighten
the bolt
【
A
】
.
◆
Tightening torque
Intake pipe assembly bolt
9.8 N·m (1.0 kgf·m, 87 in·lb)
Disassemble the thermostat and water
temperature sensor
◆
Disassembly:
【
A
】
Bolt M6×20
【
B
】
Thermostat cover
【
C
】
Thermostat
【
D
】
Water temperature sensor assembly
Install thermostat and water temperature
sensor
◆
Install the thermostat
【
C
】
, the vent of the
thermostat should be upward when installing,
aligned with the notch on the cylinder head.
◆
Install the thermostat cover
【
B
】
, and tighten
the bolt
【
A
】
.
◆
Install the water temperature sensor assembly
【
D
】
, and apply thread sealant when
installing.
◆
Tightening torque
Thermostat cover bolt
9.8 N•m (1.0kgf•m, 87 in•lb)
Water temperature sensor assembly
12 N•m (1.2kgf•m, 107 in•lb)
A
A
A
A
B
B
B
B
C
C
D
D