13 - 22
VEHICLE BODY AND FRAME
Front bumper removal
◆ Remove the lock nut of the winch motor cable, and
remove the winch motor cable.
!
After removing the motor wire of the winch, the head of
the cable should be protected to prevent short circuit.
◆ Remove the mounting bolts of the front bumper
assembly (hex flange bolts 2-M 1 0 × 1.2 5 × 20
and hexagon flange bolts M 1 0×1.2 5×2 5), nuts
( Hexagon flange face lock nut M10×1.25) and
remove the bumper assembly.
◆ Remove the mounting bolts of the front bumper trim
panel assembly (large pan-head hexagon socket
bolt 4-M6×16), and remove the front bumper trim
panel assembly.
To Next Page
Loading...
