Segway VILLIAN SSV Series - Disassemble; Installation; Start Motor

14 - 37
ELECTRICAL SYSTEM
START MOTOR
E
A
B
D
C
Disassemble
◆ The starter motor 【A】 is installed on the engine
【B】, and the disassembly method is detailed in
the engine chapter;
◆ Remove the CVT 【E】, see the engine chapter;；
◆ Remove the positive and negative wires of the
starter motor 【C】;
◆ Remove the【F】；
◆ Remove the motor 【A】 along the axis of the
motor;【A】
◆ When disassembling the motor, pay attention that
the O-ring 【H】 should not be damaged;
installation
Apply a small amount of lubricating oil to the O-ring of
the starter motor, then install the starter motor into the
crankcase along the axial direction, and fix it with two
bolts 【F】.
The positive connector of the starter motor is installed on
the starter motor, and the negative connector is installed
on the engine base 【G】;
Connect the battery.。
F
F
G
H
!
Make sure to disconnect the battery negative (-) cable
then disconnecting the battery positive (+) cable