Segway VILLIAN SSV Series - Dismantling the Reverse Gear Idler Shaft Assembly and Main Shaft Assembly; Dismantling the Right Gearbox Assembly; Dismantling the Right Gearbox Connector

4 - 16
FRONT AXLE AND REAR GEARBOX
FRONT AXLE AND REAR GEARBOX
Dismantling the right gearbox connector
【
A
】
Gear sensor assembly
【
B
】
Bolt M6×16
【
C
】
Circlip 30×2.5
【
D
】
Washer 30×40×1.5
【
E
】
L gear driven gear
【
F
】
Needle roller bearing K28×33×17
◆
Tools: 8mm sleeve, external circlip pliers.
◆
Unscrew the bolt
【
B
】
counterclockwise, remove
【
A
】
, and use circlip pliers to remove Next
【
C
】
,
remove
【
D
】
and
【
E
】
in turn.
Dismantling the right gearbox assembly
【
A
】
Bolt M8×40
【
B
】
Right gearbox assembly
【
C
】
Bolt M8×60
◆
Tool: 10mm sleeve.
◆
Unscrew the bolts
【
A
】
and
【
C
】
counterclockwise,
and remove
【
B
】
.
◆
Separate the right box assembly, if necessary, use
a rubber hammer to hit the joint surface around the
box.
Dismantling the Gear positioning bolt
【
A
】
Gear positioning bolt
【
B
】
Aluminum washer 14×21×1.5
【
C
】
Gear positioning spring
【
D
】
Steel ball 9.5
◆
Tool: 14mm sleeve.
◆
Use a sleeve to unscrew the bolt
【
A
】
counterclockwise, and take out
【
B
】
,
【
C
】
, and
【
D
】
.
Dismantling the reverse gear idler shaft
assembly and main shaft assembly
【
A
】
Reverse gear idler shaft assembly
【
B
】
Spindle assembly
◆
Remove
【
A
】
, then remove
【
B
】
.
A
A
B
B
C
C
D
D
E
E
A
A
B
B
C
C
A
A
B
B
A
A
D
D
B
B
C
C
F
F