14 - 22
ELECTRICAL SYSTEM
B
A
C
SWITCH
Power lock
!
When the indicator does not display after the key is
turned on, check the circuit failure , and replace the
power lock after confi rming that the power lock is broken
→ Check Power lock
After unplugging the connector, turn the multimeter
to the conduction position. When the key is turned to
the OFF position, the two wires should not be able to
conduct when the key is turned to the ON position, the
two wires should be able to conduct
When you need to replace the power lock, first remove
the seat cushion and fuel tank guard （see "vehicle body
and frame"
）
.
【A】Ignition lock cover
【B】Ignition lock
【
C
】
Connector
◆ After removing the plastic parts, rotate the ignition
lock cap counterclockwise【A】.
◆
Remove connector
【
C
】，
Replace ignition lock
.
When in normal condition, ON is directly above,
clockwise rotation of 60 degrees is OFF
At ON, the vehicle circuit connected, the key can not be
pulled out
At OFF, the vehicle circuit is disconnected and the key
can be removed
To Next Page
Loading...
