Segway VILLIAN SSV Series - Measure Oil Pressure; Oil Pressure

ENGINE LUBRICATION SYSTEM
3-1-9
Measure oil pressure
◆
Connect the oil pressure gauge connector
【
C
】
to
the oil pressure gauge
【
B
】
◆
Clean the area around the oil pressure sensor
【
A
】
and remove the oil pressure sensor
◆
Connect the oil pressure gauge connector
【
C
】
◆
Start the engine, make the engine reach working
temperature, observe the reading of the oil pressure
gauge
Special tools
：
Oil pressure gauge
，
10 kgf/cm
2
: E01GZ0030001
Oil pressure gauge connector: E01GZ0031001
Oil pressure requirement (heat engine state)
More than
69 kPa (10psi) @1400r/min (rpm)
More than 276 kPa (40 psi) @7000r/min (rpm)
◆
Shutdown engine
.
◆
Remove the oil pressure gauge and connector
!
WARNING
When disassembling the pressure gauge connector,
pay attention to prevent the hot engine oil from being
scalded. The hot engine oil will fl ow out through the oil
passage.
◆
Install the oil pressure sensor and tighten it to the
specifi ed torque
◆
Tightening torque
Oil pressure sensor
15 N·m (1.5 kgf·m, 11 ft·lb)
Oil pressure
Oil pressure
A
A
B
B
C
C