6 - 9
COOLING SYSTEM
Remove the oil radiator
[A] Oil radiator mounting bracket bolt M6X30
[B] Water inlet connecting hose clamp
[C] Oil radiator inlet and outlet hose clamps
【D】Oil radiator
◆ Disassemble the plastic parts of the rear car body
and the oil radiator guard (see the car body part for
details)
◆ Use a suitable tool to remove the water filler
connection hose clamp [B] and the oil radiator water
inlet and outlet hose clamp [C], pull out the water
fi ller connection hose and the oil radiator water inlet
and outlet hoses.
◆ Remove the mounting bolts of the radiator
◆ Remove the oil radiator
Remove the engine raditor
[A] Mounting bracket bolt on engine radiator M6X25
【B】Radiator vent pipe clamp
[C] Engine radiator inlet and outlet hose clamp
【D】Engine radiator
【E】Upper bracket of radiator
◆ Disassemble the front plastic part of the vehicle
head
◆ Use a suitable tool to remove the clamp [B] of the
engine breather pipe and the clamp [C] of the engine
radiator water inlet and outlet hoses, and pull out the
RADIATOR REMOVAL
B
C
D
C
A
A
B
C
D
E
!
◆ The start and stop of the radiator fan are controlled
by the vehicle ECU. When the water temperature
of the engine cylinder head reaches 88°C, the fan
automatically starts; until the water temperature of
the cylinder head drops below 83°C, the radiator
fan automatically stops. Do not touch the radiator
fan when it is rotating, as this may cause injury.
◆ When disassembling the radiator, it must be done
in a low temperature vehicle and in a flameout
state.
To Next Page
Loading...
