Segway VILLIAN SSV Series - Remove; Voltage Regulating Rectifi er Inspection

14 - 16
ELECTRICAL SYSTEM
A
B
C
Voltage regulating rectifi er inspection
Test and Judgment Method of Charging Voltage on Whole Vehicle
Test conditions and methods Output voltage
Connect the product according to the normal loading
state, after the vehicle started, the speed will remain
above 2000rpm
Connect a fully charged battery
Use a multimeter to test the voltage at the output terminal
of the regulator
Output voltage:14.0-15.0V
Qualifi ed otherwise unqualifi ed
Remove
◆ Connector【A】（Disconnect）
◆ Bolt【B】and Voltage regulating rectifi er【C】
See the table below for the determination method of the
voltage regulating rectifi er resistance:
Output resistance characteristics（unit Ω）
Output + Y1 Y2 Y3 Output-
Digital multimeter
(Diode gear)
Output+
∞ ∞ ∞
∞
Connect the red pen to output +, and the
black test pen to measure the remaining
terminals
Y1 0.12-0.25
∞ ∞ ∞
Connect the red pen to Y1, and the
black test pen to measure the remaining
terminals
Y2 0.12-0.25
∞ ∞ ∞
Connect the red pen to Y2, and the
black test pen to measure the remaining
terminals
Y3 0.12-0.25
∞ ∞ ∞
Connect the red pen to Y3, and the
black test pen to measure the remaining
terminals
Output- 0.5-0.7 0.4-0.6 0.4-0.6 0.4-0.6
Connect the red pen to output -, and the
black test pen to measure the remaining
terminals
Output resistance characteristics（unit Ω）