14 - 21
ELECTRICAL SYSTEM
A
B
Remove front cover (see the "Frame" chapter)
【A】Install rubber sleeve
【
B
】
Flasher
Disassembly
Remove the installation rubber sleeve【A】from the
installation bracket
Remove the wiring harness connector
Replace the fl asher【B】
→ TEST
◆ If the turn signal does not flash or flashes
abnormally on the whole vehicle (the normal turn
signal fl ash frequency is 85/min)
◆ The lamp is out of light (one-side forward or
backward turn light is damaged), and the turn
signal fl ashes at a frequency of 120/min）
FLASHER
To Next Page
Loading...
