10 - 14
WHEELS AND TIRES
B
A
B
A
◆ Check whether the rim lines 【A】 on both sides
of the tire are parallel to the anti-slip rim/rim fl ange
【B】 and the surrounding relative clearance is
uniform.
If the rim line and the rims/rim fl ange are not parallel or
the relative gap around the tire is uneven, bleed the tire,
re-lubricate the sealing surface, and then re-inflate the
tire.
◆ Check whether there is air leak after the tire is in
place correctly.
◆ Apply soap solution to the tire rim, and check
whether there is air bubble.
◆ Bleed the tire to the specifi ed pressure.
◆ Check the tire pressure with the barometer.
Segway off ers tire pressure gauges and user kits.。
Tire pressure (in cold state)
Front: 120Pa（1.2kgf /cm
2
，18psi）
Rear: 120kPa（1.2kgf /cm
2
，18psi）
◆ Wheel mounting (see Wheel mounting).
◆ Wipe the soap and water solution from the tire and
dry the tire before operation.
!
Do not operate the vehicle with soap and water around
the wheel rim.
It can cause tyre separation and can lead to dangerous
conditions.
Tire check
◆ Refer to the "Wheels/Tires" section of the Regular
Maintenance section.
To Next Page
Loading...
