Segway VILLIAN SSV Series - Electrical Wiring; Wiring Check

14 - 31
ELECTRICAL SYSTEM
ELECTRICAL WIRING
Wiring check
◆
Visually inspect the wiring for signs of ablation, wear, etc.
◆
Remove each connector
【
A
】
and check for corrosion, dirt and damage.
◆
Remove each connector
【
A
】
and check for corrosion, dirt and damage.
如果损坏，请更换。
Check the continuity of the wire
◆
Refer to the electrical schematic diagram to find the wire end suspected to be
problematic.
◆
Connect the manual tester (multimeter) to both ends of the wire.
◆
Set the manual tester (multimeter) to the on-off gear.
If the reading of the manual tester (multimeter) is not 0 or the buzzer does not work, the
wire is defective if necessary, replace the wire or the main harness
【
B
】
.