Segway VILLIAN SSV Series - Electronic Accelerator Pedal; Remove and Install the Accelerator Pedal

14 - 64
ELECTRICAL SYSTEM
ELECTRONIC ACCELERATOR PEDAL
Remove and install the accelerator pedal
◆ Unplug the wire harness connector and remove 3
self-locking bolts with the nail sleeve (see figure B
on the left).
◆ The fastening torque of the mounting bolt of the
accelerator pedal module should be less than 10Nm,
recommended value 8Nm(M6), connect the harness
connector.
◆ Impurity must be prevented during and after the
installation of the accelerator pedal module quality
entry, otherwise may predamage the throttle pedal
module function.
!
The accelerator pedal module must be installed and
fi xed in accordance with the drawings.Don't Allow to use
the accelerator pedal module to support other parts, do
not allow to disassemble any parts.
Electronic accelerator pedal connector pin defi nition:
【
A
】
: 5V power supply for accelerator pedal 2
【B】 : 5V power supply of accelerator pedal 1
【C】 : accelerator pedal 1 ground wire
【
D
】
: Acceleration pedal sensor 1
【E】: Acceleration pedal 2 ground wire
【F】: Acceleration pedal sensor 2
B
A B C D E F