Segway VILLIAN SSV Series - Battery Charging; Battery Disassembly; Electrical and Ignition System

2 - 28
MAINTENANCE
ELECTRICAL AND IGNITION SYSTEM
Battery disassembly
!
If the electrolyte overfl ows, immediately wash it off with
a solution of 1 tablespoon baking soda and 1 cup water
to prevent damage to the vehicle.
The battery is located behind the driver seat. If you
want to replace or maintain the battery,please follow the
following steps:
Cut off the power before removing battery
【
A
】
Driver's seat
【B】Battery protective cover
【C】Battery
【
D
】
Battery strap
【E】Battery positive wire
【F】Battery negative wire
◆
Please remove the seat
【
A
】
.
◆ Hold the groove behind the battery guard plate with
your hands and move forward, and remove the
battery board;
◆ Remove the battery strap；
◆ Turn up the Protective rubber sleeve；
◆
Remove the battery negative pole screw and
disconnect the black (negative)【F】 battery cable.
◆ Remove the battery positive pole screw and
disconnect the red (positive)
【
E
】
battery cable.
◆ Remove the battery from the vehicle。
Battery charging
!
When charging, the hydrogen produced by the 12V
battery is combustible explosive gas.Therefore, please
follow the following precautions before charging:
If charging the 12V battery is still installed in the car, be
sure to disconnect the ground cable.
Make sure the power switch on the charger is off when
connecting and disconnecting the charger cable to the
12V battery.
Only charge slowly (5A or less).If charged quickly, the
12V battery may explode.
B
C
D
E
F
A