14 - 24
ELECTRICAL SYSTEM
Flameout Switch
When the engine is running, press the stop switch button
to stop the engine
When the engine is stopped, first press the stop switch
button and then press the start button to start the engine;
When the function fails, check the related circuit fi rst
When there is no problem in the inspection circuit, test
the internal circuit of the fl ameout switch;
!
Only when the fl ameout switch is in working condition,
the engine can be started by pressing the start button
→ Test whether the fl ameout switch is damaged
When the flameout switch is pressed, red, gray and
yellow should be able to conduct, and black and gray
and black should be able to conduct, and when the
start button is pressed at this time
When the flameout switch is pressed, red, gray and
yellow black, gray and black can not be conducted
Emergency switch
When the emergency switch is pressed, the four front
and rear turn signals fl ash at the same time
When the emergency switch is pressed, if a single turn
signal does not light up, the relevant insurance or the
lamp itself should be checked.
→ Test whether the emergency switch is damaged
When the emergency switch is pressed, if the four
front and rear turn signals do not flash, the internal
circuit of the emergency switch should be tested
When the emergency switch is not pressed, there
should be no conduction in orange, gray, and light
blue;
When the emergency switch is pressed, the
orange,gray, and light blue should be able to conduct
at the same time
A
To Next Page
Loading...
