8 - 12
DRIVE SYSTEM
INSTALLATION OF DRIVE SHAFT
◆ Install a new retaining ring in the spline groove
【A】, apply anti-biting agent on the spline;
◆ The spline of the driving shaft is aligned with the
diff erential spline, push inward along the horizontal
arrow direction, and load the driving shaft;
◆ If necessary, use a rubber mallet to hit the outer end
of the drive shaft, into the drive shaft;
◆ Steering knuckle, rocker arm, steering rod, shock
absorber, etc., should be assembled in reverse
according to the above disassembly sequence.
A
To Next Page
Loading...
