8 - 6
DRIVE SYSTEM
DISASSEMBLY OF THE MIDDLE SECTION OF THE DRIVE SHAFT
【E】Bearing seat
【F】 Butter nozzle
◆ Remove bearing seat [E]
!
Need to check whether the bearing has abnormal noise
or large gap or excessive wear, if any defects need to
replace the bearing seat as a whole.
◆ Filling with grease
◆ When the inspection finds that the grease in the
drive shaft is reduced, or every time the vehicle
drives，After 2000Km, it needs to be lubricated by
the grease zerk【F】using grease gun tool.
DRIVE SHAFT MAINTENANCE
E
F
To Next Page
Loading...
