Segway VILLIAN SSV Series - Optional Tappet Specifi Cations; Selection of Valve Tappet

CYLINDER HEAD, CYLINDER, PISTON
CYLINDER HEAD, CYLINDER, PISTON
3-5-22
Optional tappet specifi cations
Part number F01A20007- 001 002 003 004 005 006 007 008 009 010
3 digits 480 482 484 486 488 490 492 494 496 498
Part number F01A20007- 011 012 013 014 015 016 017 018 019 020
3 digits 500 502 504 506 508 510 512 514 516 518
Part number F01A20007- 021 022 023 024 025 026 027 028 029 030
3 digits 520 522 524 526 528 530 532 534 536 538
Part number F01A20007- 031 032 033 034 035 036 037 038 039 040
3 digits 540 542 544 546 548 550 552 554 556 558
Part number F01A20007- 041 042 043 044 045 046 047 048 049 050
3 digits 560 562 564 566 568 570 572 574 576 578
TIPS
Valve clearance specifications and measured valve
clearance are calculated in millimeters (mm). A 480
tappet means that the center thickness of the tappet
【
A
】
is 4.80mm.
Selection of valve tappet
Selection of valve tappet
A
A
The valve tappet part number is F01A20007XXX, and
"XXX" corresponds to the specifi ed tappet thickness. As
shown in the following table:
are adjusted.
◆
Reinstall the camshaft and camshaft cover, and
tighten the bolts as required.
◆
Tightening torque:
Bolt (M6)
9.8 N•m (1.0kgf•m, 87in•lb)
◆
Measure and confirm that each valve clearance is
within the required range.
If the valve clearance is not within the required range,
repeat this procedure.