Segway VILLIAN SSV Series - Camshaft Installation; Timing Adjustment

CYLINDER HEAD, CYLINDER, PISTON
CYLINDER HEAD, CYLINDER, PISTON
3-5-19
Camshaft installation / timing adjustment
Camshaft installation/timing adjustment
◆
Rotate the engine so that the top dead center (TDC)
mark of the magneto rotor is aligned or in the center
of the crankshaft position sensor (CPS) mounting
hole.
◆
In accordance with the intake and exhaust camshaft
marks made during disassembly. If you install a new
camshaft or the camshaft is not marked, you can
compare it with the electronic catalog according to
the part number on the camshaft.
◆
Before installation, lubricate all camshaft tips and
journal surfaces with engine oil.
◆
Put the intake and exhaust camshafts into the
corresponding cylinder head bearing seats. Turn the
camshaft so that the cam lobe points outwards.
◆
Installation:
【
A
】
Cylindrical pin 6×10
【
B
】
Camshaft cover assembly
【
C
】
Bolt M6×35
◆
Tighten the camshaft cover mounting bolts
【
C
】
in
order.
◆
Tightening torque
Bolt
M6
9.8 N•m (1.0kgf•m, 87in•lb)
!
CAUTION
CAUTION
If any parts in the valve train have been replaced,
please refer to the valve clearance adjustment
procedure sequence.
1
1
10
10
11
11
12
12
7
7
2
2
6
6
3
3
8
8
9
9
4
4
5
5
C
C
B
B
A
A