8- 15
DRIVE SYSTEM
◆ First install the small clamp, adjust the position of
the dust cover to ensure that the dust cover is stuck
in the groove of the intermediate shaft, and then use
clamp pliers to clamp the small clamp
◆ When installing the large clamp, first clip the dust
cover into the groove of the universal joint, and then
exhaust the gas in the dust cover. Use a screwdriver
to lift up a corner of the dust cover, being careful not
to puncture the dust cover, and then go back and
forth. Push and pull the universal joint, you can hear
the sound of gas fl owing, stay the universal joint in
the middle position, take out the screwdriver and
clamp the big clamp
◆ Wipe clean the grease on the universal joint and the
intermediate shaft and then use it
◆ The above maintenance procedures are applicable
to the inner ball cage of the front drive shaft
To Next Page
Loading...
