9 - 15
FRONT & REAR SUSPENSION
Front Rocker arm disassembly
【A】 rocker arm buff er sleeve
【B】 Rocker arm liner
【C】 dust cover
【D】 oil cup
【E】 on the kingpin
【F】 Under the kingpin
【G】 Retainer ring for shaft
◆ Removal of Dust Cover from both ends 【A】;
◆ Pressure out of Rocker arm liner 【B】;
◆ Pressure out of the two ends of the rocker arm buff er
sleeve 【C】;
◆ Removal of oil cup 【D】;
◆ Disassembly of shaft with retaining ring 【E】;
◆ Using a bearing driver, pressing out the kingpin
component through a press 【E】【F】;
-- Special equipment: clamp clamp, bearing driver
Rocker arm assembly mounting bolts/
steering rod end nuts
45 N·m
（
4.5 kgf·m
，
33ft·lb
）
Mounting bolts for stabilizer bar assembly
25N·m（2.5kgf·m，18 ft·lb）
A
B
C
D
A
C
E
F
F
F
Rear Rocker arm disassembly
【A】 Steel wire retainer for hole
【B】 Plain bearings
◆ Steel wire retaining ring for holes 【A】
◆ Use the bearing driver, press out the plain bearing
【B】
-- Special equipment: clamp clamp, bearing driver
A
B
To Next Page
Loading...
