Segway VILLIAN SSV Series - Page 94

CRANKCASE\CRANKSHAFT\BALANCE SHAFT
3-4-21
◆
◆
Align the position and load the lower crankcase.
Align the position and load the lower crankcase.
◆
The rubber hammer can be gently tapped around
the crankcase to ensure that there is no gap on the
sealing surface of the upper and lower cases.
◆
◆
Screw in four M8 bolts, eight M10 bolts, and one M6
Screw in four M8 bolts, eight M10 bolts, and one M6
bolt.
bolt.
!
CAUTION
CAUTION
Replace the M10 bolt each time you install the crankcase.
◆
Tighten the bolts in place in sequence.
Bolt M10
one step:: 12 N·m (1.2 kgf·m, 8.6
ft·lb
ft·lb)
two step:
：
28 N·m (2.8 kgf·m, 20.6
ft·lb
ft·lb)
three step: turning 90°
Bolt M8
35 N·m (3.5 kgf·m, 26
ft·lb
ft·lb)
Bolt M6
12 N·m (1.2 kgf·m, 106 in
·lbs
·lbs)
◆
Turn the crankcase and screw 2pcs M8 bolts and
11pcs M6 bolts into the upper crankcase.
M8
M10
M6
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
10
10
11
11
12
12
13
13
M8
M6