ACUSON Cypress™ Operator’s Manual 6-5
Cardiac Calculations Setup
How to Edit the Estimated Value While Performing a
Calculation
To make a one-time change to an estimated value (the system will revert back
to the setup default after this calculation), follow these steps while performing a
calculation:
1. Click the field. For example, click [PRESSURE] to display the default esti-
mated RA Pressure of 10 that was specified in the Setup menu.
2. Click [PRESSURE] a second time to open the edit box.
3. Type in a new estimate and click the [SET] button.
Selecting a Report Format
1. Press the SETUP key and click the Calculations heading.
2. Click Reports. Select either the Complete format or the Configured format.
A report in the Complete format displays the entire report, including sec-
tions with open data fields.
The Configured format displays only the sections where data has been
entered.
Selecting a Report Background Color
1. Press the SETUP key and click the Calculations heading.
2. Click Reports.
3. Select a color.
Using the Averaging Function
When averaging is turned ON, measurements that are part of the patient report
will automatically display the averaged result when two or more of the same
measurements are completed. To turn averaging
ON, follow these steps:
1. Press the SETUP key and double-click the Calculations heading.
2. Highlight Averaging. A checkmark indicates if the averaging function is
active. If it is not, click the checkbox to turn averaging
ON. (To turn averaging
OFF, click the checkbox to remove the checkmark.)
NOTE Averaging can be activated or deactivated on a per-study basis using
the patient information screen independent of the system wide selec-
tion in the Setup Menu.
To Next Page
Loading...
