Basic Setup
3-14 ACUSON Cypress™ Operator’s Manual
Recalling a Saved Preset on the New Patient Screen
When a new patient is added to the system, you can assign a Preset to it by fol-
lowing these steps:
1. Press PATIENT.
2. Click [NEW PATIENT].
3. Add the patient data.
4. Click [PRESETS].
5. Highlight a Preset from the pull-down menu and press <ENTER> to select it.
6. Click [LOAD]. The Preset is loaded when live imaging begins.
NOTE If a Preset is removed (i.e., deleted) after [LOAD] is clicked and
before the start of live imaging, the factory default Preset will be
loaded.
Renaming a User-Defined Preset
To change the name of an existing Preset, follow these steps:
1. Press the SETUP key.
2. Highlight the Presets heading.
3. Use the pull-down menu to select the Preset option to be renamed.
4. Click [RENAME].
5. Use the Trackball to place the cursor in the Presets text field and type a new
name.
6. Click [OK].
Removing a User-Defined Preset
To remove an existing Preset, follow these steps:
1. Press the SETUP key.
2. Highlight the Presets heading.
3. Use the pull-down menu to select the Preset option to be deleted.
4. Click [REMOVE].
NOTE If a Preset is removed (i.e., deleted) after [LOAD] is clicked and
before the start of live imaging, the factory default Preset will be
loaded.
To Next Page
Loading...
