Transferring Studies
9-4 ACUSON Cypress™ Operator’s Manual
Default Gateway: See your Network Administrator to determine your
Default Gateway. This address is required for systems on inter-networks.
If this address is not provided, IP functionality will be limited to the local
subnet.
Use DHCP. Click this checkbox if there is a Dynamic Host Configuration
Protocol (DHCP) server on your network. If one is present, your network
configuration settings are complete. If your network does not have a
DHCP server, you must specify the IP Address, Subnet Mask, and
Default Gateway of your Cypress system.
4. If you made changes in the Cypress Network Identification window you must
restart the Cypress system by shutting it down and then starting it again. The
network changes will take effect when the Cypress system is restarted.
DICOM Format to a DICOM Server via a Network
If the network option is installed, images can be sent in DICOM format to a net-
worked
DICOM server. The images can be transferred uncompressed, or com-
pressed in Run Length Encoded (
RLE), or JPEG compressed formats. Studies
saved on the server can be opened for review on a networked
DICOM review
station
Restrictions:
It is up to the user to determine compatibility between the Cypress system’s
DICOM images and the DICOM
server and review station. Refer to the DICOM
Conformance Statements for the Cypress system, the server, and the review
station for their respective capabilities. The
DICOM Conformance Statement
for the Cypress is located in the Operator's Manual Reference supplement
and also on the ACUSON web site (www.acuson.com).
It is recommended that the transfer to the server be confirmed at the server
before the study is deleted from the Cypress system internal hard drive.
Some DICOM viewers may experience problems reading long loops. The
Cypress system can save loops that range in size from a single frame to the
maximum of 32 seconds. Select a loop size that is compatible to your
DICOM
viewer.
To Next Page
Loading...
