Siemens ACUSON Cypress

ACUSON Cypress™ Operator’s Manual 9-21
Transferring Studies
Troubleshooting a Network DICOM Transfer
When transferring studies to a DICOM server, an error may be detected. Table
44 describes the possible errors and solutions.
TABLE 44. Network Errors
Error Solution
Could not establish a connec-
tion to the server - Verify
failed, Save canceled
The Cypress system did not receive
a response to its Verification (C-
Echo) command. Check the
DICOM
server settings on the
DICOM Setup
page and verify that the server is
on-line and retry.
Could not establish an associa-
tion with the server - Save
canceled
The server rejected the Cypress
system connection, most likely due
to an image format incompatibility.
Check
DICOM compatibility by refer-
ring to the Cypress system and
DICOM server's DICOM Conform-
ance Statements.
DICOM Error: C-STORE response =
xxxx, do you wish to continue?
The server sent back an error code
on the save. Consult your server's
error code information for more
details. If you want to continue the
save, click [
YES]. To abort the save,
click [
NO]. The error will appear only
if the Ignore Server Response
checkbox is not checked (see Table
41 on page 9-6).
A network timeout error has
occurred - Save canceled
The Cypress system received a
time-out error. Verify that the server
is on-line.
An internal DICOM error has
occurred - Save canceled
Verify that the server is on-line. Test
the connection by using the
[
VERIFY] button on the DICOM
Server Information section located
in the Setup menu.