Cardiac Calculations
6-14 ACUSON Cypress™ Operator’s Manual
Changing the Position of a CALC Menu
To change the position of a CALC menu, follow these steps:
1. Place the cursor on a border of the CALC menu and press <ENTER>.
2. To move the menu ...
downwards, place the cursor on the bottom border.
upwards, place the cursor on the top border.
to the left, place the cursor on the left border.
to the right, place the cursor on the right border.
diagonally, place the cursor on the corners of the menu.
Setting a Default Position for the CALC Menu
The factory default location for the CALC menu is the upper right corner of the
Cypress system screen. You can change the default using this procedure. At
any time you can also change the location of the menu to any corner using the
method described in “Changing the Position of a CALC Menu” on page 6-14. If
you change the position of a menu or menus during an exam, reset the menus
to the user-defined default position by clicking the [
RESET] button. The menus
will also return to the user-defined default position when the Cypress system is
powered down.
To set the default position of the
CALC menus, follow these steps:
1. Press the SETUP key.
2. Double-click the Calculations entry on the Setup listing.
3. Highlight Menu Position. A menu opens on the right side of the screen. It
shows arrows pointing in four directions—each with its own radio button. For
example, if the radio button for the upper left option () is selected, the
CALC
menus will be displayed in that screen position.
4. Click the radio button that corresponds to the corner of the screen where you
want the
CALC menus located.
5. Press the SETUP key to exit the menu.
To Next Page
Loading...
