Siemens ACUSON Cypress

ACUSON Cypress™ Operator’s Manual 3-17
The System Menu
TABLE 5. System Menu Fields
Field Description
Transducers Double-click Transducers to display a list of com-
patible transducers. Highlight each transducer and
use the pull-down menu on the right side to select a
default protocol.
Setting a Default Protocol for Transducers
A default protocol is assigned to each transducer by
the manufacturer and can be redefined by the user.
The default protocol should be the protocol that is
used most often for each transducer. To select a dif-
ferent default protocol, follow these steps:
1. Press SETUP, double-click System, and then
double-click Transducers.
2. Highlight a transducer (for example, AcuNav) and
select a default protocol from the pull-down menu
at the right of the screen.
3. Continue until each transducer has been
assigned a default protocol.
Options Highlight Options to display the following informa-
tion:
 Enable Password Modification Click the check-
box to enter a new password.
 Password Passwords are issued by Siemens.
Passwords are unique to each Cypress system
and cannot be transferred. Do not delete an exist-
ing password until a new password has been
issued.
 Enabled The window shows the options that are
enabled for this system.
 Ethernet Address Factory set and cannot be
changed. This address is used to identify the
Cypress system when new passwords are issued.
 Service Information Stores service information.
Put the cursor in the field and then enter the name
and phone number of your service representative.