SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
8-13
8.2.8 Technical specifications
Special module DSe ST
RSe ST
DSe HF
RSe HF
sDSSte /
sDSte
sRSSte /
sRSte
Dimensions and weight
Installation measurements (mm):width
height
depth
110
230
150
110
230
160
Weight (g) DSe / sDSSte / sDSte:
RSe / sRSSte / sRSte:
1385
1655
1395
1665
1700
1875
Module-specific data
Permitted service position vertical, horizontal
Vibrations tested complying with IEC 60 068, Part 2-6 2g
Vibrations tested complying with IEC 60 068, Part 2-27 half-sine 15 g / 11 ms
Allocation type complying with IEC 947-4-1 1
Pollution degree complying with IEC 60 664 (IEC 61 131) 3
Type of protection complying with IEC 60 529 IP65
Shock protection protected against touching by fingers
Control current circuit
Rated operating current for electronics L+ / M DC 24 V (20.4 V - 28.8 V)
Rated operating current for electronics 1L+ / 1M ca. 40 mA
Rated operating current for contactor activation 2L+ / 2M ca. 200 mA
Main circuit
Power output of 3-phase motors at 400 V max. 5.5 kW
Utilization categories AC-1, AC-2, AC-3, AC-4 AC-53a
1)
(max. 9 A
with deacti-
vated soft
start-up up to
Class 10)
Rated operating current I
e
at 30 °C (see Chapter 3.3)
• AC-1 / 2 / 3
- at 400 V
- at 500 V
• AC-4 at 400 V
0.15 A ... 2 A / 1.5 A ... 12 A
0.15 A ... 2 A / 1.5 A ... 9 A
0.15 A ... 2 A / 1.5 A ... 4 A
see Chap-
ter 3.3 and
Chapter 8.3,
switching
frequencies
2)
1) 8-hour operation
2) 2 A: AC53a 6 – 9 70 – 150
9 A AC53a 6 – 9 30 – 22
12 A AC53a 5.5 – 12 30 – 11
Rated operating voltage
• Approval according to EN 60947-1 Appendix N
• Approval complying with CSA and U
L
400 V
up to 400 V
up to 600 V
400 V
up to 400 V
up to 480 V
Connection cross-section, power infeed max. 6 x 4 mm²
Switching times at 0.85 ... 1.1 x U
e
• Closing time
• Opening delay
11 ms ... 50 ms
5 ms ... 45 ms
—
Mechanical service life, contactor 30 million switching
cycles
—
Electrical service life of contactor see Figure 8-7 —
Table 8-3: Technical data of the motor starters
To Next Page
Loading...
