Siemens SIMATIC ET 200pro - Quick guide to commissioning; 2.1 Introduction and aim of the example

SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
2-1
Quick guide to commissioning 2
2.1 Introduction and aim of the example
Introduction
On the basis of the following example, you will learn how to commission the
ET 200pro with motor starters step by step.
The DSe standard direct starter is controlled via an ON switch and on OFF
switch connected to an 8 DI DC 24 V ST module.
The software 'HW Config' is used for configuration (project planning).
Aim of the example
This example is intended to
1. show you how to commission a simple DSe standard direct starter with
ET 200pro in a few steps
2. enable you to modify this example for your application
3. help you implement other applications easily
Essential steps
The essential steps with ET 200pro are always:
• Assembling the ET 200 pro components as well as the external wiring of operating
elements (switches) and actuators (e.g. motor)
• configuring with STEP 7
• integration into the user program
• switching on the ET 200pro
• evaluating the diagnosis