Applications
SIMATIC - ET 200pro motor starter
C-6 GWA 4NEB 950 5661-02 DS 04
C.1.3 For hot swapping
The following example shows a configuration with direct infeed to each motor
starter. There is short-circuit protection of the configuration outside the
ET 200pro. The direct infeed into each motor starter means that individual motor
starters can be replaced during operation. At the motor starter, each connection
X3 of the power bus must be covered by a sealing cap.
Figure C-3: Configuration for hot swapping
Num-
ber
Order number Description
1 6ES7194-4GB10-0AA0 Wide module holder, 1 m
1 6ES7154-2AA00-0AB0 Interface module IM 154-2 DP with terminating module
3 3RK1922-2BA00 Bus module
1 3RK1304-5xS40-4AA0 Motor starter DSe-ST
1)
1 3RK1304-5xS40-2AA0 Motor starter DSe-HF
1)
1 3RK1304-5xS40-3AA0 Motor starter RSe-HF
1)
3 3RK1902-0CK00 Sealing cap for power bus
3 3RK1911-2BEx0 Connector set for power infeed
1)
3 3RK1902-0Cx00 Connector set for motor connection
1)
1) x = corresponding version
Interface
module
DSe,
Standard
RSe,
high feature
DSe,
high feature
Wide module holder (for motor starters)
Terminating module
To Next Page
Loading...
