Siemens SIMATIC ET 200pro - 9.2 Cutting power cables to length

Connecting
SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
9-3
9.2 Cutting power cables to length
9.2.1 To cut power cables to length, you require:
• For assembly of the sockets and pins on the individual wires, a crimping tool
(see Chapter A.2).
As well as the following accessories:
• For infeed to special modules (assignment of X1, see Chapter 9.2.2),
for infeed to motor starters (assignment of X1, see Chapter 9.2.3):
– A flexible Cu cable with 4 x 2.5 mm
2
/ 4 mm
2
/ 6 mm
2
(3-wire + PE)
– A power plug connector HAN Q4/2 socket
- for 2.5 mm
2
: 3RK1911-2BE50
- for 4.0 mm
2
: 3RK1911-2BE10
- for 6 mm
2
: 3RK1911-2BE30
• For power loop-through to the special modules RSM and F-RSM
(assignment of X2, see Chapter 9.2.2):
– A flexible Cu cable with 4 x 2.5 mm
2
/ 4 mm
2
/ (3-wire + PE)
– A power plug connector HAN Q4 / 2-pin
- for 2.5 mm
2
: 3RK1911-2BF50
- for 4.0 mm
2
: 3RK1911-2BF10
• For consumer unit connection to the motor starter
(assignment of X2, see Chapter 9.2.3):
– A flexible Cu cable with 1.5 mm
2
or 2.5 mm
2
- without brake control: 3-wire + PE
- with brake control: 5-wire + PE
– A power plug connector HAN Q8/0 pin
- for 1.5 mm
2
: 3RK1902-0CE00
- for 2.5 mm
2
: 3RK1902-0CC00
Figure 9-1: Example: Power infeed
SF
BF
ON
DC 24V
MSMS
Connector set
7-pin (socket)
angled cable routing
Energy infeed
MM