Siemens SIMATIC ET 200pro - Switching on

SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
2-9
2.8 Switching on
1. Switch on the following voltage supplies at the ET 200pro.
- Do not switch on 1L+ and 2L+ via the IM 154-. module supply voltage AC
400 V yet!
2. Observe the status LEDs on the DP master and ET 200pro.
- CPU 315-2 DP:
DC 5 V: lights up
SF DP: Off
BUSF: Off
3. Observe the status LEDs on the IM 154-. DP, high feature.
- SF Off
- BF Off
- ON green
- DC 24 V green
4. Observe the status LEDs on the 8 DI DC 24 V
- DI
0
Off
- DI
1
green
- DI
2
Off
- DI
3
Off
5. Observe the status LEDs on the motor starter DSe
- SF Off
- STATE Off
- DEVICE green