Siemens SIMATIC ET 200pro - Figure 7-11: Assignment of the Connectors on the Disconnecting Module 400 V

SIMATIC - ET 200pro motor starter
7-12 GWA 4NEB 950 5661-02 DS 04
7.4.5 Assignment of the main power connections
Figure 7-11: Assignment of the connectors on the disconnecting module 400 V
7.4.6 Response to fault
If an internal fault occurs, the outputs remain without current and the fault is
indicated by the LED 'SF' and indicated via bus as a diagnosis alarm. In this
case, the defective module must be replaced.
Number Connection X1
HAN Q4/2 (pin)
Connection X2
HAN Q4/2 (socket)
1 Phase L1 Phase L1
2 Phase L2 Phase L2
3 Phase L3 Phase L3
4— —
11 — —
12 — —
e PE PE
X1 X2
43
21
12 11
34
12
11 12