Siemens SIMATIC ET 200pro - Table 10-2: Basic Parameters - Settings

SIMATIC - ET 200pro motor starter
10-4 GWA 4NEB 950 5661-02 DS 04
Protection against voltage failure (can only be parameterized for high feature motor
starters)
You use this parameter to retain the last overload signal
•Overload
• No overload
10.2.2 Parameter settings
The following table shows the settings of the basic parameters:
Device parameters Default Adjustment range
Rated operating current
)
2.0 A
12.0 A
Increment: 10 mA
0.15 A to 2.0 A
1.5 A to 12.0 A
Load type 3-phase 3-phase / 1-phase
Protection against voltage failure Yes Yes / No
1) Rated power of the motor at 400 V AC
Table 10-2: Basic parameters – settings