Data formats and data records
SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
D-21
D.3.8 Data record 93 – write command
Structure of the command data record
Byte Meaning Note
Command data record
Header label
0Coordination
0x20 write via C1 channel (PLC)
0x30 write via C2 channel (PC)
0x40 write via device interface (PC)
1…3 Reserved
Command
4 Number of commands Value range 1…5.
Number of subsequent valid commands
5 Command 1 Serial no., see table below
6 Command 2 Optional (coding see table below)
7 Command 3 Optional (coding see table below)
8 Command 4 Optional (coding see table below)
9 Command 5 Optional (coding see table below)
Table D-11: Structure of the command data record
ID no. Coding Command Meaning
1-byte commands
0 0 Reserved No function
703 1 Trip reset Resets and acknowledges error messages
713 2 Emergency start ON —
714 3 Emergency start OFF —
709 4 Operating mode Auto-
matic
Transition to Automatic operating mode
(control by DP master)
710
711
712
5 Manual operating mode
- bus
- local
Transition to manual operating mode. The motor
starter switches to 'Manual bus operating mode' or
'Manual operation local operating mode' depend-
ing on the interface across which the command is
received.
701 6 Factory setting Recover factory setting of the parameters from
DS 128
704 7 Delete maximum
pointer
The measured values for preventive diagnosis are
deleted (= 0).
715 8 Program memory
module
Not supported
702 9 Restart Trigger new start (same as after mains power ON),
e.g. after reassignment of the station address.
707 10 Parameterization lock
CPU / Master ON
No parameterization by parameterizing master is
possible, or its parameters are ignored
Table D-12: Data record 93 – write command
To Next Page
Loading...
